Mounting the meeting room screen

The screens can be mounted to solid or partition walls using the mounting plate supplied in the box and suitable fixings.

Screen with mounting plate connected shown in yellow

*Glass wall: If fixing the screen to a glass wall you need the optional glass mount kit. Contact your Condeco account manager for more details about the glass mount kits.

Cable Routing

There are three cable entry points on the mounting plate located top left/right and bottom center, as shown in the illustration.

Mounting plate showing cable entry points

*Consider the location of the cable entry points when deciding where to mount the meeting room screen. Typically, the power or network cable runs aside, or inside the door frame, and enters the mounting plate from the side.

The mounting plate contains knockout points for when the screen is positioned over the cable point in the wall.

Mounting plate showing knockout points

Recommended screen height

The final screen height should be determined by local disability access requirements. The ADA (Americans with Disabilities Act) guidelines require that the highest point of interaction is not greater than 48 inches or 1220mm. We find 1150mm – 1170mm from the bottom of the device typically a suitable height.

*If possible, fit the device on the side of the wall nearest the door handle!

Further reading

• Fixing to a solid wall
• Fixing to a glass wall
• Connecting the cables and screen
• Screen commission prerequisites