How to power the Meeting Room Screens

The 10.1” V2 Meeting Room Screens are designed to be powered via POE (Power Over Ethernet) and have the ability to work on both 48V and 56V POE inputs. The screens are compatible with both 10/100 and Gigabit Ethernet switches. If your IT infrastructure has powered Ethernet ports on your Ethernet switches then there are no additional power supplies or switches required to power the 10.1” V2 screens.

POE Injectors

In certain scenarios, external power supplies may be required. For example, if your IT infrastructure doesn’t have enough free powered Ethernet ports, or if you wish to use Wi-Fi to connect the screens to the booking system.

In this case, we recommend using a single port or multiport POE Injector – depending on the number of screens being powered. The recommended models are:

Multiport POE

Netgear FS116

Single port

Phihong POE16R-1AFG

The Phihong POE16R-1AFG needs additional plug clips depending on the market it’s shipped to. Please see ordering information below:

PLUG CLIP US
PLUG CLIP EU
PLUG CLIP UK

These models have been tested, verified and certified for use in the US, Europe, China, Japan, and Singapore markets.

Additional 12V Input

The part number of the 12V supply for information is VEP24US12 and is available on Digikey here.

This power supply needs additional plug clips depending on the market it’s used. Plugs are available on Digikey and are listed below for reference.

PLUG CLIP EU
PLUG CLIP US
PLUG CLIP UK

Power button

The power button is located on the rear of the meeting room screen on the lower edge, right-hand side (when looking at the front of the screen).

Feedback

Was this helpful?

Yes No
You indicated this topic was not helpful to you ...
Could you please leave a comment telling us why? Thank you!
Thanks for your feedback.

Post your comment on this topic.

Please do not use this for support questions.
Condeco Support

Post Comment